Section 3 - On the Water
Page 66 90-866938081 MAY 2009
3. VesselView displays a pop‑up screen warning. The operator must determine it is safe
to turn the boat. If so, press the "WAYPOINT SEQUENCE" button to acknowledge that
it is safe for Pilot to automatically turn the boat and maneuver to the new course.
Pop‑up screen warning
4. If the waypoint is not acknowledged, the boat continues on its current heading.
5. At the end of the Track Waypoint course, input a new route or take control of the
boat. Otherwise, the boat reverts to Auto Heading mode and continues on its last course
heading.
WAYPOINT SEQUENCE
1. Place the ERC lever or levers into forward. "WAYPOINT SEQUENCE" does not
engage if the levers are in neutral or reverse.
2. If the Track Waypoint button light is not on, press the "TRACK WAYPOINT" button.
3. Press the "WAYPOINT SEQUENCE" button to engage Waypoint Sequence mode.
27703
"WAYPOINT SEQUENCE" mode button
To Next Page
Loading...
