Section 5 - Maintenance
90-866938081 MAY 2009 Page 117
2. Check that any viewing systems such as VesselView, if equipped, are securely
mounted.
3. Check for loose, damaged, or corroded wiring and connectors.
4. Contact your Cummins MerCruiser Diesel Authorized Repair Facility for correction or
repair if necessary.
Cleaning Gauges
Clean gauge by washing with fresh water to remove sand and salt deposits. Wipe off with
a soft cloth moistened with water. The gauge may be scored or damaged if wiped with
abrasive material (sand, saline or detergent compounds, etc.) or washed with solvents such
as trichlorethylene, turpentine etc.
Electrical System
1. Check for loose, damaged, or corroded fasteners.
2. Check for loose, damaged, or corroded wiring and connectors.
Cooling System and Exhaust System
1. Inspect the cooling and exhaust systems for damage or leaks.
2. Check the cooling and exhaust system hose clamps for tightness.
Lubrication
Driveshaft Slip‑Joint
The driveshaft has a slip‑joint that must be lubricated through a grease fitting. Part of the
protective driveshaft shield must be temporarily removed for access to the grease fitting.
1. Remove the driveshaft shield on the engine end.
Shield on engine end
a - Driveshaft shield
b - Screw (two on each side)
c - Engine end