Section 3 - On the Water
90-866938081 MAY 2009 Page 49
3. The "1 LEVER" button light turns on.
4. Place the starboard ERC lever into gear.
5. The engine RPM raises and lowers simultaneously while the transmissions remain in
the same gear.
To disengage the single lever (1 Lever) mode:
1. Place both ERC levers in neutral.
2. Press the "1 LEVER" button. The "1 LEVER" button light turns off.
SYNCHRONIZING THE ENGINES
The system features an automatic engine synchronization feature called Sync. Sync
engages automatically at key‑up. The synchronization feature monitors the position of both
ERC levers. If both levers are within 10% of one another, the port engine synchronizes to
the starboard engine's RPM.
VesselView shows an orange icon if the RPM of the engines are not within 10% of each
other, and the icon turns green when they synchronize. The icon turns grey when Sync
mode is off.
To disengage Sync mode:
1. Place the ERC levers in any detent.
2. Press the "SYNC" button.
31467
"SYNC" button
To re‑engage Sync mode, press the "SYNC" button.
Cruise Control
The VesselView system features integrated throttle cruise control called Cruise, which
allows the operator to limit the peak RPM of choice below wide open throttle (WOT). Refer
to the owners manual provided with your VesselView for operation instructions.
These additional notes are exclusive to your package:
• You can change or disengage Cruise through the VesselView screen at any time.
• Cruise resets when the key is turned off.
• If the cruise limit is changed while the levers are at WOT, Cruise gradually changes to
the new speed.
• Cruise does not disengage if the ERC levers are at a higher engine speed than the
actual RPM. Bring the levers back to the forward detent, then use VesselView to
disengage Cruise.
• Skyhook does not function if Cruise is engaged.
To Next Page
Loading...
Need help?
General