Section 2 - Getting to Know Your Power Package
90-866938081 MAY 2009 Page 19
Circuit breakers and fuses provide protection for the electrical system as indicated. The
circuit breakers and fuses are located in various locations throughout the boat. Have your
dealer show you the location and identify the circuit that they protect.
After finding and correcting the cause of the overload, reset the circuit breaker by pressing
the reset button.
VESSEL INTERFACE PANEL (VIP) OVERLOAD PROTECTION
The Vessel Interface Panel (VIP) contains six circuit breakers that help protect the
transmission harness, engine harness, vessel sensor harness, and helm harness.
NOTE: A VIP for each engine is located in the engine room.
All similar
Item Circuit Breaker Rating Protection Location on VIP
a 15 A Gear Upper left
b 10 A SIM/Vessel Middle left
c 10 A Helm Lower left
d 5 A Engine Diagnostics Upper right
e 5 A VIP Diagnostics Middle right
f 25 A Main Lower right
OVERLOAD PROTECTION FOR THE DC VOLTAGE REGULATOR SYSTEM, IF EQUIPPED
If the vessel is equipped with a 24‑volt system, a DC voltage regulator is required to supply
12‑volt power to the VIP and the other 12‑volt circuits. The power package manufacturer
provides a protective fuse for the 24‑volt DC to 12‑volt DC voltage regulator system, if
equipped. The spade‑style, in‑line fuse is located in the harness between the voltage
regulator and the 24‑volt battery system. The fuse protects the wiring and the regulator
against overloads.
To Next Page
Loading...
