Section 3 - On the Water
Page 60 90-866938081 MAY 2009
NOTE: The joystick must move over 50% of its travel for the movement to be recognized
as input.
24707
Adjusting heading to starboard
TO RESUME A HEADING
The "RESUME" button light is on if the previous course heading is available to resume.
IMPORTANT: The previous heading can only be resumed within one minute of Auto
Heading being disengaged or if the boat has not turned more than 180°.
Press the "RESUME" button to resume the previous heading if you:
• Turned the steering wheel and disengaged Auto Heading.
• Pressed one of the "TURN" (course adjust) buttons with Auto Heading engaged.
27700
a - "TURN" button
b - "RESUME" button
c - "AUTO HEADING" button
DISENGAGING AUTO HEADING
1. Disengage the Auto Heading mode with any of the following actions:
• Place the ERC handles for both engines in neutral. The "AUTO HEADING" button
light turns off and the Standby light comes on.
• Turn the steering wheel beyond the electronic detent. The "AUTO HEADING"
button light turns off and the Resume light comes on.
To Next Page
Loading...
Need help?
General