Section 3 - On the Water
90-866938081 MAY 2009 Page 61
• Press the "AUTO HEADING" button on the Precision Pilot keypad. The "AUTO
HEADING" button light turns off and the Standby light comes on.
27700
a - "TURN" button
b - "RESUME" button
c - "AUTO HEADING" button
2. A single horn beep sounds and the mode indicator changes from "AUTO" to "OFF".
3. If Auto Heading disengaged because the steering wheel was turned, the Resume
button light turns on. While the Resume button light is on, you can press the
"RESUME" button to resume the course in Auto Heading. See To Resume a
Heading. If you do not wish to resume the course, press the "AUTO HEADING" button
once to engage Standby and press it again to turn the Auto Heading mode off.
a - Mode indicator—"OFF" or "AUTO"
b - Current heading
c - Drive positions
d - Engine RPM
4. If the ERC Handles were moved to neutral, Auto Heading turns off the "STANDBY"
light turns on. You cannot resume your course by pressing the "RESUME" button. See
To Resume a Heading.
5. If Auto Heading disengaged because the "AUTO HEADING" button was pressed, the
"AUTO HEADING" button light turns off and the Standby light comes on. Press the
"AUTO HEADING" button a second time and the Standby light goes off, Auto Heading
is disengaged, and the mode is off.
To Next Page
Loading...
Need help?
General