Section 9 - Pre-Delivery Information
90-866938081 MAY 2009 Page 151
Before Starting—Key Off
Dealer Check Checklist Item Manual Code or Task
☐ Identification Record table listed on front page is filled out. ZOM
☐ Copy of all required support publications present Visual Inspection
☐ Drive skegs and propellers are installed Visual Inspection
☐ Engine mount and isolator mounting capscrews are tight Visual Inspection
☐ Driveshaft and shields mount cap screws are tight Visual Inspection
☐ All fuel connections are tight Visual Inspection
☐ Raw water (seawater) system hose clamps are tight Visual Inspection
☐ Exhaust system hose clamps are tight Visual Inspection
☐ All electrical connections secure Visual Inspection
☐ Coolant recovery bottle and expansion tank level—check/fill QSB OM Section V
☐ Engine oil level—check/fill QSB OM Section V
☐ Steering actuator and trim fluid level—check/fill ZOM Section 5
☐ Transmission fluid level—check/fill ZOM Section 5
☐ Drive gear lube fluid level—check/fill ZOM Section 5
☐ Seacocks open (See Starting and Stopping the Engines.) ZOM Section 3
Before Starting—Key On
Dealer Check Checklist Item Manual Code or Task
☐ Audio warning horn chirp at key on VVM Section 8
☐ Check the VesselView for fault codes VVM Section 8
☐ Neutral lights on the ERC lever assembly ZOM Section 3
Engines Running at the Dock
Dealer Check Checklist Item Manual Code or Task
☐ Key switch and/or Start / Stop buttons—operational check ZOM Section 3
☐ Check sea water flow—visual check at bypass port Visual Inspection
☐ Throttle only / Gear lockout—operational check ZOM Section 3
☐ Forward ‑ Neutral ‑ Reverse gear—operational check ZOM Section 3
☐ Idle increase / decrease—operational check ZOM Section 3
☐ E‑Stop switch, if equipped—operational check ZIM Section 2
☐ Exhaust leaks—visual check Visual Inspection
☐ Fluid leaks—visual check Visual Inspection
☐ Drive interface ring seal (sealing grommet)—visual check for leaks Visual Inspection
To Next Page
Loading...
Need help?
General