Section 5 - Maintenance
Page 98 90-866938081 MAY 2009
6. Install a suitable gear lube pump into the gearcase fill and drain hole. Fill the drive with
the specified gear lube.
a - Fill and drain hole
b - Gear lube and pump
7. Continue to pump gear lube into the drive until the gear lube appears in the gear lube
monitor at the "COLD FILL LEVEL" line. Do not overfill.
"COLD FILL LEVEL" line
Drive Model
Fluid Capacity (includes
the drive and the gear
lube monitor)
Fluid Type Fluid Part Number
Zeus 5‑1/4 L (5‑1/2 US qt)
High Performance Gear
Lube
92‑858064K01 1 L (1 US qt)
92‑858065Q01 9.5 L
(2.5 US gal)
8. Remove the gear lube pump and quickly reinstall the gear case fill and drain screw and
washer.
Description Nm lb‑in. lb‑ft
Gear case fill and drain screw 6.7 60 –
9. Fill the gear lube monitor to the "COLD FILL LEVEL" line, if the level is low. Refer to
Filling.
10. Ensure that the rubber gasket is inside the cap for the gear lube monitor and install the
cap. Do not overtighten.
11. Install the drive propellers. Refer to Propellers.
12. Check the gear lube level at the gear lube monitor after the first use. Refer to
Checking.
To Next Page
Loading...
Need help?
General