Section 5 - Maintenance
90-866938081 MAY 2009 Page 101
2. Remove the cap and dipstick. Push down and turn the reservoir cap and dipstick about
1/3 turn in the open direction.
a - Reservoir cap and dipstick
b - Open direction
c - Close direction
IMPORTANT: Always use the dipstick to determine the exact quantity of oil required.
3. Fill the hydraulic reservoir with the specified oil to bring the level up to the full‑cold
mark. Do not overfill.
a - Cap and dipstick
b - Full‑cold mark
c - Low‑cold mark
d - Add
Tube Ref No. Description Where Used Part No.
138
Synthetic Power Steering Fluid
SAE 0W-30
Hydraulic system 92-858076K01
4. Insert the cap and dipstick into the neck of the reservoir. Push down and turn the
reservoir cap in the close direction.
To Next Page
Loading...
