Section 5 - Maintenance
90-866938081 MAY 2009 Page 105
1. To access the transmission dipstick, you must remove the access cover or remove the
drive cover, if equipped. Refer to Removing the Drive Cover.
a - Access cover
b - Transmission
c - Transmission dipstick
2. Remove the dipstick. Wipe the dipstick with a clean, lint‑free cloth. Check the oil level
as outlined in Checking.
Transmission dipstick
3. Add the specified transmission oil through the dipstick threaded hole to bring the level
up to the maximum mark on the dipstick.
Description Fluid Capacity Fluid Type Fluid Part Number
Transmission only
(without drop box)
4 L (4‑1/4 US qt)
Synthetic Power
Steering Fluid SAE
0W‑30
92‑858077K01
Transmission and drop
box
5‑1/4 L (5‑1/2 US qt)
Transmission, drop box
and remote (engine
mounted) transmission
oil cooler
5‑1/2 L 6 US qt)
IMPORTANT: For a more accurate measurement, operate the engine at 1500 RPM for
three minutes immediately before checking the oil level.
NOTE: Additional transmission oil may be required to fill empty cavities in the transmission
filter and oil coolers after changing the transmission oil. Always use the dipstick to establish
the correct oil level.
4. Start the engine and operate at 1500 RPM for three minutes to fill all of the hydraulic
circuits and empty cavities.
To Next Page
Loading...
