100
Chapter 4 Congure the Router in Wireless Router Mode
1. In the System Time section, select the way in which the router gets its time: Get
from Internet, Get from Managing Device, Manually.
2. Select your local Time Zone.
3. Enter the address or domain of the NTP Server I or NTP Server II.
4. Click SAVE.
• To set up Daylight Saving Time:
1. In the Daylight Saving Time section, tick the Enable box.
2. Select the start time from the drop-down list in the Start elds.
3. Select the end time from the drop-down list in the End elds.
4. Click SAVE.
Note:
This setting will be used for some time-based functions such as rewall. You must specify your time zone once you log in to
the router successfully; otherwise, time-based functions will not take eect.
To Next Page
Loading...
