Metrohm 930 Compact IC Flex - Page 33

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Installation
930 Compact IC Flex Oven/SeS/PP (2.930.2500)
￭￭￭￭￭￭￭￭
25
6
Mounting the adsorber tube
NOTE
Depending on the eluent used, the adsorber tube (6.1609.000)
must be filled differently:
￭ For alkaline eluents or eluents with a low buffer capacity: first a
little cotton, then with CO
2
adsorber material.
￭ For all other eluents: only with cotton.
￭ Remove the plastic cover from the large opening of the adsorber
tube. Fill the adsorber tube and close it again using the plastic
cover.
￭ Insert the adsorber tube into the bottle cap's large opening. Fas-
ten it to the bottle cap using the SGJ clip (6.2023.020).