￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
930 Compact IC Flex Oven/SeS/PP (2.930.2500)
￭￭￭￭￭￭￭￭
III
Table of contents
1 Introduction 1
1.1 Instrument description ......................................................... 1
1.2 Accessories and additional information ............................. 3
1.3 Symbols and conventions .................................................... 3
2 Safety 5
2.1 Intended use ......................................................................... 5
2.2 Responsibility of the operator ............................................. 5
2.3 Requirements for operating personnel ............................... 6
2.4 Safety instructions ................................................................ 6
2.4.1 General notes on safety ........................................................... 6
2.4.2 Electrical safety ........................................................................ 6
2.4.3 Tubing and capillary connections ............................................. 7
2.4.4 Flammable solvents and chemicals ........................................... 8
2.4.5 Recycling and disposal ............................................................. 8
3 Overview of the device 9
3.1 Front ...................................................................................... 9
3.2 Rear ...................................................................................... 10
3.3 Feed-throughs for capillaries and cables .......................... 12
4 Installation 15
4.1 Setting up the instrument .................................................. 15
4.1.1 Packaging .............................................................................. 15
4.1.2 Checks .................................................................................. 15
4.1.3 Location ................................................................................ 15
4.2 Capillary connections in the IC system ............................. 15
4.3 Removing transport locking screws .................................. 18
4.4 Connecting the drainage tubing and leak sensor ............ 19
4.4.1 Installing the drainage tubing ................................................ 19
4.4.2 Connecting the leak sensor .................................................... 21
4.5 Column oven ....................................................................... 21
4.6 Connecting the eluent bottle ............................................. 22
4.7 Installing the high-pressure pump .................................... 26
4.8 Installing an inline filter ..................................................... 27
4.9 Installing the pulsation absorber ...................................... 27
To Next Page
Loading...
