￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Operation and maintenance
930 Compact IC Flex Oven/SeS/PP (2.930.2500)
￭￭￭￭￭￭￭￭
81
Inserting a new filter
1
Inserting a new filter
￭ Use tweezers to carefully place a new filter into the filter screw
(23-2) so that it is flat and press it firmly into place with the rear
of the tweezers.
2
Installing the filter screw
￭ Screw the filter screw (23-2) back into the filter housing (23-1)
and tighten by hand. Then use two adjustable wrenches
(6.2621.000) to tighten it slightly.
3
Remounting the inline filter
￭ Screw pressure screws back onto the inline filter.
Take care to ensure that the flow direction matches that inscribed
on the inline filter.
4
Rinsing the inline filter
￭ Dismantle the guard column (if present) and the separation col-
umn and replace with a coupling (6.2744.040).
￭ Rinse the instrument with eluent.
￭ Reinsert the columns after 10 minutes.
To Next Page
Loading...
