Metronix ARS 2100 SE Series User Manual

Page 136
Error message Meaning of the error message Measures
Main
index
Sub
index
4 FSM: Fault in SSIO
communication
Cause: Error in the internal communication
connection between the basic device
and the safety module.
Action:
 Identify interfering radiators in the
environment of the servo drive.
 Replace module or basic device.
 Please contact the Technical
Support.
5 FSM: Fault in FSM break
control
Cause: Internal hardware error (brake
activation control signals) of the safety
module or fieldbus activation module.
Action: Module presumably defective. If
possible, replace with another module.
Cause: Error in brake driver circuit section in
the basic device.
Action: Basic device presumably defective. If
possible, replace with another basic
device.
6 FSM: Non-identical module
serial number
Cause: Serial number of currently connected
safety module is different from the
stored serial number.
Action: Error only occurs after replacement of
the FSM 2.0 MOV.
 With module replacement: Module
not yet configured. Accept currently
integrated FSM 2.0 MOV.
 Check parameterisation of the
FSM 2.0 – MOV with regard to the
application as modules have been
replaced.
52 1 Safety function: Discrepancy
time overrun
Cause: Control ports STO-A and STO-B are
not actuated simultaneously.
Action: Check discrepancy time.
Cause: Control ports STO-A and STO-B are
not wired in the same way.
Action: Check circuitry of the inputs.
Product Manual „Servo drives ARS 2100 SE“ Version 5.0

Metronix ARS 2100 SE Series Specifications

General

Brand	Metronix
Model	ARS 2100 SE Series
Category	Servo Drives
Language	English