ML-30
MevaLite
Fillers
MevaLite Fillers
Fillers that are 2"or 3" wide can be
formed using MevaLite aluminum
fillers without additional steel rails
(Fig.30.1).
1" MevaLite aluminum fillers
require steel rail supports (see
"Job-Built Fillers" below).
Job-Built Fillers
Fillers up to 6.5" wide can be
formed using 4 1/4" deep lumber
and MevaLite panels. Uni-
assembly locks are used to connect
the adjacent panels with the filler
in between. Fillers wider than 6.5"
can be formed using 3/4" plywood
with 3 1/2" deep lumber. Refer to
the remainder of this section for
additional filler information and
requirements.
Fillers Up to 6.5" Wide
Steel rails are required at each tie
hole elevation. They are installed
either between two ties (Fig.30.2),
or cantilevered over one tie to
support the filler and adjacent
MevaLite panel (Fig.30.3). The rail
supported panel next to the filler
can be up to 3' wide.
2" or 3" aluminum filler
(ties must be installed in
filler tie holes)
Fig. 30.1
Fig. 30.2 Fillers up to 6.5" wide, rails between two ties
Fig. 30.3 Fillers up to 6.5" wide, cantilevered rails
2" aluminum filler
6.5" max.
Wood filler
Flange screw 18
Rail must cross over adjacent panel frame
RAIL 6'
RAIL 3'
3" aluminum filler
3" AF
3" AF
2" AF
2" AF
RAIL 3'
1" AF
Wall formwork
Technical Instruction Manual / June 2022
To Next Page
Loading...
