4 – Control CS 310 / Rev.I 1.55 Control CS 310 / Rev.I 1.55 – 5
4 – Control CS 310 / Rev.I 1.55
Information concerning operation
− Unauthorised persons (particularly children) should not be
allowed to play with permanently installed adjusting or
control devices.
− Keep remote controls beyond the reach of children.
− In general, an original wiring harness from MFZ GmbH &
Co. KG must be used for the connection between the door
motor and controller. Changes or replacements shall only
take place following consultation with the manufacturer
and approval by the same.
Observe the valid standards and regulations!
4. Product overview
4.1 4.1 Product descriptionProduct description
The controller CS 310 is designed for use in industrial areas
and can be used with all door types in these areas. It is pos-
sible to connect motors with mechanical limit switches (MEC)
or an electronic limit position system (AWG).
All the necessary command devices and safety elements can
be connected, set and evaluated.
Programming takes place via a pluggable LCD monitor.
The following supplier variants of the controller CS 310 are
possible:
4.2 4.2 VersionsVersions
Housing variants:
− Controller CS 310 in the “standard” housing
− Controller CS 310 in the “combination” housing with inte-
grated mounting rail for additional components
Variants of the pluggable LCD monitor:
− LCD monitor on the circuit board
− LCD monitor in the housing cover
− Without LCD monitor (monitor is required for all settings
apart from the limit position setting)
Command device variants:
− 3-fold button CS integrated in the housing
Optional:
− Housing without 3-fold button
− Housing with ON/OFF key switch
− Housing with main switch
− Housing with emergency stop
− Pluggable components (circuit board)
− Week timer
− Radio receiver
− Radio transmission system for closing edge protective
device and/or a safety element.
The operating instructions describe the connection and pro-
gramming options and variants of the controller CS 310 with
connected LCD monitor and from software version V1.55j.
General safety instructions