16 – Control CS 310 / Rev.I 1.55 Control CS 310 / Rev.I 1.55 – 17
EN
6. Initialisation
The following components will be recognised and taught-in
automatically during initial operation and following a RESET.
− End position system
− Closing edge safety device
− Photocell system
− Input 2 (Safety input)
During this process (approximately 90 seconds) the green LED
ashesandthetoplineofthedisplayshowsthemessage
“PLEASE WAIT ...”.
It is not possible to operate the system during this process.
The end position system must be installed before initial
operation.
Components can be changed or added at a later date using
the LCD display or by reinitialising the system.
If one of the components has not yet been connected, this
will be indicated by “A“ in the display.
This component will be searched for if any further
initialisation procedure is carried out. If this component
is recognised, the system automatically switches to the
appropriate adjustment mode.
Exception:
Input 2 remains inactive (MOD1), if a resistance value is not
detectedwithrstinitialisation.
Ifaresistorisdetectedatinput2withrstcommissioning,
this is evaluated as a safety element and put into operation as
a safety input.
➔ “10.2 Input operating mode“ / Parameter INPUT 2
NOTICE:
In addition to “teaching in” the various system components,
the initialisation process allows you to change the menu
language directly.
The menu language pre-set in the factory (GERMAN) is
displayedasaashingtextforapproximately60seconds.
The desired language can be selected using the [+] and [–]
buttons and saved by pressing the [P] button. After this, all
texts or messages displayed are shown in the language that
you have selected.
To Next Page
Loading...
Need help?
General
