System Commands AccuPyc II 1340
3-16 Aug 2013
This prompt enables you to select the printer you wish to use
for generating reports. This is a system option and does not
have to be specified for each analysis (or calibration). It also
applies for all units when multiple analysis modules are
attached.
Choices: Canon Bubble Jet, Epson ESCP, Epson ESCP2,
Epson ESCP Raster, HP PCL 3, HP PCL 6XL,
PostScript
Refer to SUPPORTED PRINTERS, page G-1 for
information on the printers supported by the AccuPYC.
Press
CHOICE to select the appropriate printer, then press
ENTER.
Select the format of data to be used when transmitting
reports. Refer to TRANSMITTED DATA, page D-1 for the
format used when transmitting data.
Choices: Single column, Spreadsheet
Press
CHOICE to select the format, then press ENTER.
Prompts for a MultiVolume insert during analysis or calibra-
tion operations.
Choices: Yes or No
An insert is a device you can place in your sample chamber,
allowing you to use a smaller sample cup for analysis of
smaller sample quantities. Inserts are available in MultiVol-
ume Kits for the 1.0-, 10-, and 100-cm
3
pycnometers. Refer
to ORDERING INFORMATION, page 6-1 for informa-
tion on placing an order.
If you are not using MultiVolume inserts, ensure that No is
selected, then press
ENTER.
Unit[n] SN1234 10 cm3
Report Options
Printer?
Epson ESCP2
Unit[n] SN1234 10 cm3
Report Options
Transmission Format?
Single column
Unit[n] SN1234 10 cm3
Report Options
Request insert?
No
To Next Page
Loading...
