AccuPyc II 1340 System Commands
Aug 2013 3-15
The description prompt enables you to enter additional
descriptive information.
This prompt typically is used when a computer keyboard is
attached to the USB port. A keyboard also enables you to
execute all system commands, avoiding having to switch
back and forth between the computer keyboard and analyzer
keypad. Refer to KEYBOARD INTERFACE, page I-1 for
a list of keypad/keyboard equivalents.
Press
CHOICE to select Ye s or No, then press ENTER.
This prompt enables you to have a report generated automat-
ically after an analysis or calibration.
Choices: Yes, No
The type of printer is selected at the Printer? prompt shown
on page 3-16.
Press
CHOICE to select Ye s or No, then press ENTER.
This prompt enables you to transmit analysis or calibration
data automatically after the operation. Refer to TRANS-
MITTED DATA, page D-1 for the format.
Choices: Yes, No
Press
CHOICE to select Ye s or No, then press ENTER.
This prompt enables you to e-mail analysis or calibration
results automatically at the conclusion of the operation.
Choices: Yes, No
If you choose Yes , an e-mail address and server must be
specified (refer to Communications, page 3-18).
Press
CHOICE to select Ye s or No, then press ENTER.
Unit[n] SN1234 10 cm3
Report Options
Request description?
No
Unit[n] SN1234 10 cm3
Report Options
Print Report?
No
Unit[n] SN1234 10 cm3
Report Options
Transmit Report?
No
Unit[n] SN1234 10 cm3
Report Options
E-mail Report?
No
To Next Page
Loading...
