Miele PG8582 CD - Configuring Interface Parameters Details

Further settings
92
Configuring the
interface
 The interface must only be configured by suitably qualified and
competent persons.
 Open the menu as follows:
 button
Further settings
Interface
Interface
Ethernet
RS232
– Ethernet
Configuration of an Ethernet interface
– RS232
Configuration of a serial RS-232 interface
 Select the type of interface and confirm your selection with OK.
Then the parameters for the interface must be configured.
Ethernet
– Module status
Connection status displayed (Active/Inactive).
– Address status
List of interface parameters, e.g. IP address, Subnet mask etc.
– DHCP
The Ethernet interface can either be implemented via a Dynamic
Host Configuration Protocol (DHCP) or by setting the following
parameters:
– IP address
– Subnet mask
– Standard gateway
– DNS server automatic
– DNS server 1
– DNS server 2
– Port type
– Port