3-25
1
1
3
Useful Function
5
6
Cut Out Data with Registration Mark
3
Move the Light Pointer into the area shown below by
pressing the appropriate ones of the jog keys
and .
4
Press the key.
• The scale compensation display appears.
(The right figure shows the 4-point detection display as an example.)
5
Make setting with the jog key or .
• Press the key to change the display to the next scale
compensation setting.
• If [DIST.REVI.] is set to [OFF], the display for scale compensation
setting will not appear.
• If [MARK DETECT] its set to [2ptA], the display for inputting the B length
will not appear.
• If [MARK DETECT] is set to [1pt], the scale compensation setting
display will not appear but the origin point will be displayed.
6
Press the key after completing the
settings.
• The plotter will start detecting the registration marks according to
the settings of [MARK DETECT].
• See “Setting the Number of Registration Mark Detection” ( P.3-
18) for the number of registration marks.
• In case the plotter cannot detect any registration marks, it displays
“Error C36 in the registration mark detection” on the display. Set the
sheet again.
7
Set the origin.
• The display will show the available cutting area and then return to
local mode.
To Next Page
Loading...
