To Next Page

To Previous Page

Loading a sheet of media ..................................... 2-11

Loading a leaf sheet (cut sheet) .............................2-14

How to Place the Roll Sheet ................................... 2-16

Test cutting (plotting) ........................................... 2-18

Cutting (plotting) ................................................... 2-19

Setting the origin ..................................................... 2-19

Start cutting (plotting) ............................................. 2-20

Turning the power off ........................................... 2-21

CHAPTER 3 Useful Function

Functions in the Jog Mode ..................................... 3-2

Setting the origin ....................................................... 3-2

Two-point axis alignment .......................................... 3-3

Cutting area ..............................................................3-4

Digitization operation ................................................ 3-5

Set the distance compensation .............................. 3-6

Perform Multiple Cuttings ..................................... 3-10

Expand the cutting (plotting) area ........................ 3-12

Set the EXPANDS function to ON. ......................... 3-12

Switch the cutting (plotting) direction ................... 3-14

The Setting of ROTATION. ..................................... 3-14

Perform DIVISION CUT. ...................................... 3-16

Set for DIVISION CUT. ........................................... 3-16

Cut Data via DIVISION CUT. .................................. 3-18

Change the cutting (plotting) order ...................... 3-19

Set SORTING . .......................................................3-20

Sorting sequence ....................................................3-22

Other Useful Functions ........................................ 3-23

Feed the paper .......................................................3-23

HOLD ......................................................................3-24

DATA CLEAR - Discontinue Plotting - .................. 3-25

Perform SAMPLE CUT to Find out the Cause of

Cutting Error. ..........................................................3-26

Output the Setting List ............................................ 3-27

Output the received data by the ASCII code

[ASCII DUMP] ......................................................... 3-28

Set each device number for USB connection ......... 3-29

Perform cutting a dotted line ................................... 3-30

Perform plotting with perforated lines ..................... 3-32

MIMAKI CG-60SL User Manual

Other manuals for MIMAKI CG-60SL