MIMAKI jV100-160 - Page 127

Chapter 5 Dealing with Problems
127
Error
number
Message Cause Corrective action
3. Remove the lid on the ink cartridge and
fold the ink pack. "Replacing
Ink"(P. 39)
INK LVL LOW (2nd
time)
• The ink remaining in the
600 ml cartridge is below
60 ml.
1. Remove the ink cartridge, and measure
the weight. "Correcting the Ink
Cartridge Case Weight"(P. 83)
2. Enter the measured weight into the
machine. "Correcting the Ink
Cartridge Case Weight"(P. 83)
– “Ink near end” is displayed when
the remaining ink has dropped to
less than 60 ml.
613 Ink level end • The ink remaining in the
600 ml cartridge is below
30 ml.
1. Remove the ink cartridge, and measure
the weight. "Correcting the Ink
Cartridge Case Weight"(P. 83)
2. Enter the measured weight into the
machine. "Correcting the Ink
Cartridge Case Weight"(P. 83)
– “Ink end” is displayed when the
remaining ink has dropped to less
than 30 ml.
– “Ink near end” is displayed when
there is at least 30 ml of remaining
ink. Remove the lid on the ink
cartridge and fold the ink pack.
"Replacing Ink"(P. 39)
614 Saving failed • Failed to register the ink
remaining amount of the
600 ml cartridge.
1. Check to confirm that the ink cartridge
was inserted correctly.
2. Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
627 Cartridge load • The ink IC chip could not
be read for a certain
period of time.
1. Check to confirm that the ink cartridge
was inserted correctly.
2. Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
628 Cartridge abnormality • The ink usage amount
exceeded the preset
value.
• Replace with new ink.
"Replacing Ink"(P. 39)
• Check to confirm the nozzle is not
clogged.
5