MIMAKI JV300-130 - Sensor; List of SENSOR TEST

© 2014 MIMAKI ENGINEERING CO.,LTD. 5.1.2 P.1
1
2
3
4
5
6
7
8
R.1.0
5.1.2 SENSOR
 Outline
Each sensor is tested.
 List of SENSOR TEST
Name of Test Function LCD display
COVER Displaying the status of the Cover Sensor.
(The identification by the cover name is not possible.
Because each cover sensor for series connection.)
OPEN/CLOSE
Y ORIGIN Displaying the status of the Y-origin Sensor. ON/OFF
LEVER Displaying the status of the Clamp Lever. ON/OFF
REAR PAPER Displaying the status of the Rear Paper Sensor. ON/OFF
WIPER Displaying the status of the Wiper Origin Sensor. ON/OFF
WASH CARTRIDGE Displaying the status of the Wash Cartridge Sensor. ON/OFF
WASH CART. END Displaying the status of the Wash Cartridge Near End Sen-
sor.
ON/OFF
HEAD(UPSIDE) Displaying the status of the Ink Head. ON/OFF
HEAD(DOWN-
SIDE)
Displaying the status of the Ink Head. ON/OFF
MEDIA JAM Displaying the status of the Media Jam Sensor. ON/OFF
CLEANER Displaying the status of the Cleaner. ON/OFF
PUMP MOTOR Displaying the status of the Pass Select Sensor. ON/OFF
TAKE-UP Displaying the status of the Take-Up Motor. ON/OFF (For 300 series only)
TENSION BAR Displaying the origin status of the Angle Sensor. ON/OFF
SLIT COUNT A Displaying the slit count status of the Angle Sensor. ON/OFF
SLIT COUNT B Displaying the slit count status of the Angle Sensor. ON/OFF
TORQUE LIMITTER Torque limit sensor condition of the take-up motor. ON/OFF
MAINTENANCE MANUAL > Test Items > Test Function > SENSOR
Model JV300-130/160 Issued 2014.05.30 Revised F/W ver 1.00 Remark
1.0
Rev.