MIMAKI JV300-130 - Cutter Unit

© 2014 MIMAKI ENGINEERING CO.,LTD. 6.2.11 P.1
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Disassembly and Reassembly > Ink-related Parts > Cutter Unit
Model JV300-130/160 Issued 2014.05.30 Revised F/W ver 1.00 Remark
1.0
Rev.
6.2.11 Cutter Unit
 Work procedures
1. Turn the main power OFF.
2. Remove the Front cover M and L.
3. Move slowly the carriage onto the platen by hand.
4. Loosen the screws (x2) and remove the Cutter unit.
5. Remove the connector.
6. Install using the reverse of the disassembly procedure.
7. Refer to 4.3.2 for more information on installation position
adjustments.
Cutter Unit
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode functions
mistakenly during the operation.
Cutter unit
Connector
Screw x2
R.1.0