MIMAKI JV300-130 - Wiper Unit

© 2014 MIMAKI ENGINEERING CO.,LTD. 6.3.6 P.1
1
2
3
4
5
6
7
8
6.3.6 Wiper Unit
 Work procedures
1. Remove the following covers.
• Front cover M, L
2. Remove the screws, and remove the wiper unit from the base.
3. Remove two screws, and remove the Wiper unit from the base.
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode functions
mistakenly during the operation.
Be sure to wear protective glasses and working gloves during the operation.
Ink may get into your eyes depending on the working condition, or hand skin may get rough if you touch
the ink.
Wiper Unit
Wiper unit
Remove tube
Screw
Take care not to contaminate the surroundings with
ink.
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Drive System > Wiper Unit
Model JV300-130/160 Issued 2014.05.30 Revised F/W ver 1.00 Remark
1.0
Rev.