MIMAKI JV300-130 - Wiper Cleaner Assy.

© 2014 MIMAKI ENGINEERING CO.,LTD. 6.3.7 P.1
1
2
3
4
5
6
7
8
6.3.7 Wiper Cleaner Assy.
 Work procedures
1. Remove the following covers.
• Front cover M, L
2. Remove the fitting.
3. Remove the Wiper cleaner Assy. by pushing the stopper and
slide it.
4. Reverse the disassembly procedure for reassembly.
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode functions
mistakenly during the operation.
Be sure to wear protective glasses and working gloves during the operation.
Ink may get into your eyes depending on the working condition, or hand skin may get rough if you touch
the ink.
Wiper unit
Wiper cleaner Assy.
Wiper cleaner Assy.
Push
Remove fitting
Make sure that O-ring (F seal rubber 300) is not
remaining in the joint screws.
Take care not to contaminate the surroundings with
ink.
F seal rubber 300
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Drive System > Wiper Cleaner Assy.
Model JV300-130/160 Issued 2014.05.30 Revised F/W ver 1.00 Remark
1.0
Rev.