MIMAKI JV300-130 - Drop.pos; Wf4(Large Droplet Waveform); Wf3(Small Droplet Waveform)

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.2.3 P.1
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > DROP.POS
Model JV300-130/160 Issued 2014.05.30 Revised F/W ver. 1.00 Remark
1.0
Rev.
R.1.0
4.2.3 DROP.POS
 Outline
Draw the built-in patterns, and compensate the parameter so that the drop positions of other heads are on the same
line as the drop position of reference head (Head 1A) in the Y-direction. To each of the discharged waveforms, exe-
cute [SiDir], [ReDir] and [BiDir] in each resolution.Perform adjustment in accordance with the following chart.
WF4(Large droplet waveform)
*1: The adjustment value for WF4/720dpi Hi is reflected in the WF4/360dpi Std single and reverse direction adjustment val-
ues (excluding bidirectional).
WF3(Small droplet waveform)
*2: The adjustment value for WF3/720dpi Std is reflected in the WF3/1440dpi Hi single and reverse direction adjustment val-
ues (excluding bidirectional).
 Work Procedures
1. Set Media at X-origin.
2. Select [#ADJUST] - [PRINT ADJUST].
3. Select the waveform.
[]/[] : Switches
[ENTER] : Confirms (Next)
4. Select the Y-resolution and scanning speed.
[]/[] : Y-resolution & Scanning speed change
[ENTER] : Confirms (Next)
Y-reso luti on
360 540 720 1440
BiDir SiDir ReDir BiDir SiDir ReDir BiDir SiDir ReDir BiDir
Std
O
*1
 XXXXXX
Hi X O O O O OXXXX
Y-reso luti on
360 540 720 1440
BiDir SiDir ReDir BiDir SiDir ReDir BiDir SiDir ReDir BiDir
Std
O  OO 
Hi X O O O O O O
X
*2
X
*2
O
FUNCTION
#ADJUST [ENT]
#ADJUST
PRINT ADJUST [ENT]
Set the drawing origin as follows;
(Set in [LOCAL] -> [ORIGIN SET])
X  0, Y > 0
#PRINT ADJUST
:WF3
WF4
#PRINT ADJUST
:360Std
360Std - 720Hi