MIMAKI JV300-130 - Page 145

© 2014 MIMAKI ENGINEERING CO.,LTD. 6.2.6 P.2
6.2.6 Circulation Pump
1
2
3
4
5
6
7
8
3. Remove the Motor connector.
4. Remove the Stepping motor (screw x2).
5. Remove the Circulation pump (screw x4).
6. Reverse the disassembly procedure for reassembly.
Connector
Screw
Circulation pump x2
Screws
 If reinserting the tube, cut about 5 mm from the
tube tip before reusing it.
 Do not install the ink tube in the wrong position.
To head
Filter
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Ink-related Parts > Circulation Pump
Model JV300-130/160 Issued 2014.05.30 Revised F/W ver 1.00 Remark
1.0
Rev.