MIMAKI JV300-130 - Page 158

© 2014 MIMAKI ENGINEERING CO.,LTD. 6.2.13 P.4
6.2.13 Changing Joint
1
2
3
4
5
6
7
8
 In case of W or Si ink is used :
1. [Execute [#ADJUST] — [HEAD WASH / DISCHARGE] to
discharge the ink. (Refer to 4.2.8)
2. Remove the Cartridge rear cover.
3. Remove the Tube and Fiitings Assy.
4. White ink tube: Attach the tube and fitting which is from filter
over the circulation pump to the 3way fitting.
5. Other colors tube: Attach the Stopper (M700865) to the Joint
(FittingΦ2: M603013-07, accessory parts), and attach it to the
3-way fitting.
Tube
3-way
fitting
Fitting
Make sure that O-ring (F seal rubber 300) is not
remaining in the joint screws.
Take care not to contaminate the surroundings with
ink.
F seal rubber 300
Stopper
Other colors
White ink
Use accessory joints
From circulation pump
Do not install the ink tube in the wrong position.
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Ink-related Parts > Changing Joint
Model JV300-130/160 Issued 2014.05.30 Revised F/W ver 1.00 Remark
1.0
Rev.