MIMAKI JV300-130 - Page 163

© 2014 MIMAKI ENGINEERING CO.,LTD. 6.3.2 P.2
6.3.2 Y-axis Motor
1
2
3
4
5
6
7
8
3. Loosen the screws for fixing the Y-axis motor belt tension, and
reduce the tension of the belt.
4. Remove the FG line and two connectors.
5. Remove the Y-axis motor belt, and then remove the Y-axis
motor while taking care not to drop it.
6. Reverse the disassembly procedure for reassembly.
Loosen
FG line
Remove belt
Take care not to drop
Slanting
Horizontal in the middle
Shifted lower
Horizontal but upper
Good
Example:
Good
Example:
Bad
Example:
Bad
Example:
Mount the Y-axis motor so that the belt is horizontal
and centered on the Y drive pulley (upper side is also
acceptable).
After attachment, rotate the pulley several times to
adapt the belt.
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Drive System > Y-axis Motor
Model JV300-130/160 Issued 2014.05.30 Revised F/W ver 1.00 Remark
1.0
Rev.