MIMAKI TS55-1800 - Chapter 1 Before Use (Continuing); Setting Ink: Final Steps

Chapter 1 Before Use
1-12
4
Put the 2L ink pack into the 2L eco case.
(1) Open the 2L eco case as shown on the right.
(2) Tear off the seal on the connector of the 2L
ink pack.
(3) Put the 2L ink pack facing the connector
down, and close the 2L eco case.
5
Attach the 2L eco case to the base.
• Ink is supplied to the printer connecting to the 2L
eco case.
• After 1 or 2 minutes, EMPTY lamp on the
connected printer goes out.
• Be careful of the ink IC chip direction. If it
is set in the wrong direction, ink is not
supplied properly.
Hold the cap of the ink bottle tightly with a paper
towel, and gently shake the 2L ink pack.
Repeat
(2)open to right
and left.
(1) While pressing
the finger grip,
OK
Seal remaining
No Good
• When putting the 2L ink pack, shape the
pack referring to the label in the 2L eco
case. If unshaped, you may not use up
the ink.
• Before closing the 2L eco case, make
sure the connector of the ink pack is
placed on the groove part of the 2L eco
case. If it is not placed on the groove, it
may not supply ink.
• Push the 2L eco case all the way in. If
not, it may not supply ink.
groove
part