MIMAKI TS55-1800 - Chapter 3 Setup (Continuing); External Heater and MAPS4 Settings

3-9
1
2
3
4
5
6
Chapter 3 Setup
11
Press the key several times to
end the setting.
Setting External heater
Used to set external heater to ON/OFF.
1
Press
(MENU)
in LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press
(<<)
.
4
Press to select "EXTERNAL
HEATER", and press the key.
5
Press to select set value.
• Set Value: ON/OFF
6
Press the key.
7
Press the key several times to
end the setting.
Setting of MAPS4
The MAPS (Mimaki Advanced PassSystem) function to
disperse the pass boundary to make the feeding stripes
less visible.
Setting MAPS4 Function (AUTO)
1
Press
(MENU)
in LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press
(>>)
twice.
4
Press to select "MAPS4" , and
press the key .
5
Press to select "AUTO", and
press the key.
• To select "MANUAL" for the setting, refer to P.3-9
"Setting MAPS4 Function (MANUAL)".
6
Press the key several times to
end the setting.
Setting MAPS4 Function (MANUAL)
1
Press
(MENU)
in LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press
(>>)
twice.
4
Press to select "MAPS4" , and
press the key .
5
Press to select "MANUAL", and
press the key.
• To select "AUTO" for the setting, refer to P.3-9
"Setting MAPS4 Function (AUTO)".
6
Press to select the "SPEED" (50
to 100%), and press the key.
• Select a speed for printing. By using standard
quality printing as reference, set in the direction of
minus (-) to decrease the print speed, and set in
the direction of plus (+) to increase the print
speed.
7
Press to select the "Smoothing
Lv.", and press the key.
8
Press to change the smoothing
level, and press the key.
• Set Value : 0 to 100% (set in units of 5%)
• The MAPS4 effect become strong as the set value
increase, and become weak as the set value decrease.
• Depending on the state of the heads, etc.,
the image quality deterioration may not be
improved even with this function
performed.In this case, contact our service
office or the distributor in your region.
• Changing the MAPS4 settings may change the
color tone. Check the effects before use.
• MAPS may not be effective depending on image to
be printed. Use it after checking effect in
advance.
 Conditions disabling MAPS function
The MAPS function may be disabled under the follow-
ing conditions. In addition, the MAPS may not be effec-
tive, depending on the image to be printed.
4-colors ink set
Resolution Pass Scan speed MAPS MODE
480 x 600 1 pass
Normal speed Standard
600 x 600 2 pass
6-colors, 7-colors, 8-colors ink set
Resolution Pass Scan speed MAPS MODE
480 x 600 2 pass
Normal speed Standard
600 x 600 2 pass
• If the speed is changed, NOZZLE
RECOVERY ( P.3-25) may not
become effective. Check in advance
before use.