4-5
1
2
2
4
5
6
Chapter 4 Maintenance
MAINTENANCE MENUs table
Item Setting Value Meaning
STATION
For carrying out maintenance on the carriage and station periphery.
CARRIAGE OUT
(P.4-6)
Moves the carriage out, for carrying out cleaning of the cap periphery,
head, wipers, etc.
NOZZLE WASH
(P.4-8)
1 to 99 min.
Soaks the nozzle surfaces in maintenance cleaning fluid, for carrying
out recovery from nozzle clogging or bends.
PUMP TUBE
CLEANING
(P.4-9)
Executes washing of the suction pump tubes.
CUSTODY WASH
(P.4-10)
1 to 99 min.
Carried out when the machine is going to be out of use for an
extended period. Washes the nozzles and tubes beforehand, to keep
the machine in optimum condition.
REPLACE WIPER
(P.4-17)
Used when replacing the wiper. If the wiper is replaced, the number of
times the wiper was used that is managed in this device is reset.
NOZZLE
RECOVERY
(P.4-13)
For printing using another nozzle, if nozzle wash and so forth fail to effect recovery from nozzle clogging, etc.
PRINT Prints a pattern to identify the nozzle that is clogged.
ENTRY Registers the faulty nozzle identified by "PRINT".
RESET Resets registered faulty nozzles.
CHECK Checks if a registered faulty nozzle can be recovered.
TEST PRINT ON/OFF
Selects whether or not to set the Nozzle Recovery Function during
TEST PRINT.
AUTO MAINT.
( P.4-16)
To automatically execute the various maintenance functions. Set the execution interval for each maintenance
function.
REFRESH The set value will
differ according
to the ink type
being used.
For setting the activation interval for refresh.
CLEANING
INTERVAL
For setting the activation interval for head cleaning.
TYPE
SOFT/NORMAL/
HARD
For setting the type of head cleaning.
REPLACE
WasteInkTank
(P.4-26)
Reset Waste Ink
Volume ( P.4-26)
Reset the waste ink tank usage count.
Adjust Waste Ink
Volume ( P.4-26)
Correct the error between the count value of the waste ink tank and
the actual volume.
Tank capacity
(P.4-26)
Set the capacity of the waste ink tank.
To Next Page
Loading...
