MIMAKI TS55-1800 - Chapter 3 Setup (Continuing); Drying Time and Margin Settings; Vacuum Fan Settings

3-7
1
2
3
4
5
6
Chapter 3 Setup
4
Press to select "Overprint" , and
press the the key.
5
Press to set number of Overprint,
and press the the key.
• Setting value : Host/ 1 to 9 times
6
Press the key several times to
end the setting.
Setting of Drying Time
In the drying time setting, the following items for ink drying
time are set.
• SCAN : Ink drying time for each scanning is set. (During
bidirectional printing, the machine stops for a
certain period of time specified for each of the
outward and return scanning.)
• PRINT END : Ink drying time after printing has been complete
is set.
1
Press
(MENU)
in LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press
(>>)
.
4
Press to select "DRYING TIME",
and press the key.
5
Press the key.
6
Press to set drying
time, and press the key.
• Set the drying time for canning and after printing
is completed. To enable the drying time specified
in your RIP, select "Host".
• Scanning setting value :
Host or 0.0 sec. to 9.9 sec.
• Print end setting value:
Host or 0 sec. to 120 minute.
• Item selecting : by the [][] keys
• Time setting : by the [][] keys
7
Press the key several times to
end the setting.
Setting of Left and Right Margins
Set a non-printing area along the left and right edges of
the media.
The offset value against the standard margin 15 mm is set
hereupon.
1
Press
(MENU)
in LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press
(>>)
.
4
Press to select "Margin/L" or
"Margin/R", and press the key.
5
Press to select a set value, and
press the key.
• Set value : HOST / -10 to 85 mm
6
Press the key several times to
end the setting.
Setting of Vacuum Fan
Sets the absorbability of the media.
By setting the absorption power to match the media, you
can prevent print errors due to media rise-up.
1
Press
(MENU)
in LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press
(>>)
.
4
Press to select "VACUUM FAN",
and press the key.
5
Press to select a set value, and
press the key.
• Set value : HOST/WEAK /STANDARD/ STRONG
• When you give priority to the setting at the
RasterLink side, make the setting value "Host".
• "SCAN" set in this machine is displayed as
"Pause Time per Scan" in the RasterLink.
• You cannot specify the print end at the RasterLink
side. When you set this machine to "Host",
printing will be performed in "PRINT END= 0
min." status.
• When you give priority to the setting at the RIP
software side, make the setting value "Host".
• You cannot specify the margins at the attached
RIP software (RasterLink). When you use the
RasterLink, if you set this machine to "Host",
printing will be performed in "Margins for right and
left off set value= 0 mm" status.
• The margin setting is reflected when the media
width is detected.
• Pay attention to that printing may start
on the media press if a right and left
margin is set to 5 mm or less when the
media press is used in printing.