Chapter 2 Basic Operation
2-8
Entering the media remaining amount
When [MEDIA RESIDUAL] of the machine setup is "ON"
(
P.3-17), the screen for entering media remaining
amount is displayed after detecting the media width.
1
Display the screen for entering media
remaining amount.
2
Press to enter the media
remaining amount.
3
Press the key.
About the media residual print
When [MEDIA RESIDUAL] of the machine setup is "ON"
( P.3-17), You can print a list of print the current date
and media remaining.
1
In Local, Press .
• It enters into the origin setting mode.
2
Press the key.
• Appear the confirmation screen of media
remaining print.
3
Press the key.
• Media residual print starts.
Take-up device
With the switch of the narrow take-up device, select the
take-up direction of the media or others.
Setting the torque limiter
The take-up device is provided with a torque limiter.
The take-up torque can be adjusted with the torque limiter.
(The torque limiter is set to "Medium" at delivery.)
If the tension is too strong to use a thin sheet of media,
lower the take-up torque with the torque limiter.
Clockwise turn :
Increases torque (a heavy and thicker media such as
tarpaulin or the like)
Counterclockwise turn :
Decreases torque (For light media)
InputMediaLength
Length
0.0m
Take-up unit
Direction
selector
switch
UP
(REVERSE)
The take-up device winds the
media with the printed side facing
in.
DOWN
(FORWARD)
The take-up device winds the
media with the printed side facing
out.
ON/OFF button
Turns the winding motion on/off.
(When you press the button and
operate the take-up device, the
device keeps taking up the media
until you press the button again.
*1
)
*1. You can also change the setting so that the taking-up operation only
lasts while the ON/OFF button is being pressed. For details, refer to
"Setting Take-up unit" ( P.3-14) in machine setups.
ON/ OFF button
Direction selector
switch
50% of the maximum 100% of the maximum
Scale of the torque
Adjustment nut
To Next Page
Loading...
