MIMAKI TS55-1800 - Chapter 4 Maintenance (Continuing); Replacing the Cap Absorber

4-19
1
2
2
4
5
6
Chapter 4 Maintenance
6
Remove the Cap.
• Pull it up while pushing in the protrusion of the
cap.
7
Attach a new Cap.
• Place the notch this side and securely fit until it
clicks.
8
When replacement is complete, press the
key.
9
Close the front cover, and press the
key.
• After its initial operation, the machine returns to
step 1.
Replacing the Cap Absorber
Cap Absorber (PN:SPC-0845) is a consumable item. If
the dirt is severe or the ink falls off from the carriage,
replace it.
1
Press
(MENU)
in LOCAL.
2
Press to select
"MAINTENANCE", and press the
key.
• The MAINTENANCE menu is displayed.
3
Press to select "STATION
MAINT.", and press the key.
4
Press to select "CARRIAGE
OUT", and press the key.
• The carriage moves over the platen.
5
Open the front cover.
6
Remove the Cap Absorber.
• Remove the clasps at the front (3 points) and pull
it out.
7
Insert a new Cap Absorber.
• Align the notches with the protrusions at the back
and install it.
8
When replacement is complete, press the
key.
9
Close the front cover, and press the
key.
• After its initial operation, the machine returns to
step 1.
• The Cap Absorber is an optional item. You can
buy one through your local dealer or from our ser-
vice office.
Carriage