4-14
Chapter 4 Maintenance
8
Specify the position of nozzle missing.
• Locate the missing nozzle with the right scale and
the upper scale.
• If you select "Register", without going to print, go
to the nozzle row selection procedure (step 9).
9
Press to select the Nozzle line
that needs NOZZLE RECOVERY, and then
press the key.
10
Register the Nozzle number that needs
NOZZLE RECOVERY, and press the
key.
(1) Press [][] to select the registration
number from 1 to 10, and press the [ENTER]
key.
(2) Press [][] to register the nozzle number
that needs recovery, and press the [ENTER]
key.
11
Press several times to end
the setting.
Reset the Set Value
1
Press
(MENU)
in LOCAL.
2
Press to select
"MAINTENANCE", and press the
key.
• Maintenance menu will be displayed.
3
Press to select "NOZZLE
RECOVERY", and press the key.
4
Press to select "RESET", and
press the key.
5
Press and
(PAGE >)
(<<) to select the Nozzle line that needs to
be reset, and press the key.
• A reset confirmation message will be displayed.
6
Press the key.
7
Press several times to end
the setting.
100 0102030405060708090
H1-H M
H1-G Bl
H1-F Y
H1-E K
H1-D K
H1-C Y
H1-B Bl
H1-A M
1
101
201
301
401
510 0
H1-H M
Nozzle No.
A scale of
100 nozzles
Nozzle missing # 203
Approximately 300mm
Approximately 360mm
SELECT ENTRY NOZZLE
HEAD1-A
>
>
HEAD1-B
>
HEAD1-C
>
HEAD1-D
>><<
>
HEAD1-E
Head No.
(H1 to H4)
Nozzle
line
• Up to 10 nozzles can be registered per 1
nozzle line.
• Even if you use this function, time
required for drawing does not change.
• Nozzle recovery is not applied when
printing using the lowest number of
passes.
HEAD1-A
No.1
16
No.2
128
No.3
No.4
184
OFF
No.5
OFF
>><<
Recovery nozzle No. or OFF
Registration number: 1~10
To Next Page
Loading...
