MIMAKI TS55-1800 - Chapter 3 Setup (Continuing); Density and Pre-feed Adjustments; Customizing Setting Type Names

3-10
Chapter 3 Setup
9
Press the key several times to
end the setting.
Pass density correct
If periodic shading differences are noticeable between
passes, it can be reduced by changing this setting.
1
Press
(MENU)
in LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• The setting menu is displayed.
3
Press
(>>)
twice.
4
Press to select “Pass dencity
correct” and press the key.
5
Press to select the setting value,
and press the key.
• Increase Lv, if thin areas are noticeable. Lower Lv,
if thick areas are noticeable.
• Setting value: Lv0 (no correction) to Lv8
6
Press the key several times to
finish.
Setting Pre-feed
The following effects can be expected by feeding back
and forth the media before printing.
• Prevent media from sticking to the various rollers and the
platen of this machine.
• If the wrinkle is shifted to the media, wrinkle reduction can be
expected.
1
Press
(MENU)
in LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press
(>>)
twice.
4
Press to select "Pre-Feed", and
press the key.
5
Press to set the feeding media
lengths.
• Set Value : OFF, 100 to 500 mm
• When [OFF] is set, pre-feed is not executed.
6
Press the key.
7
Press the key several times to
end the setting.
Change of setting type name
You can change the name of the setting type.
1
Press
(MENU)
in LOCAL.
2
Press to select the setting 1 to
4, then press the (Name) key.
• SETUP MENU will be displayed.
3
Change the setting type name.
4
Press the key several times to
end the setting.
• A fixed correction is applied in the initial state (Lv 3).
Change this if you can see differences in density in
the initial state.
• The characters that can be used are
alphanumeric characters and symbols.