MIMAKI TS55-1800 - Chapter 4 Maintenance (Continuing); Replacing the Media Press

4-20
Chapter 4 Maintenance
Replacing the Media Press
If the media press (PN:SPC-0789) becomes deformed
and rubs against the head, you need to replace it.
1
Turn OFF the power of the connected PC.
2
Turn the power off, by giving the
key a long press.
3
Turn off main power switch.
• Tilt the main power switch on the side of the unit
to "" side.
4
Open the maintenance cover.
5
Remove the media press stopper.
• Loosen the side screw and remove it.
6
Remove the media press.
7
Remove the slider.
• The media press is an optional item. You can buy
one through your local dealer or from our service
office.
• Make sure you do not lose the slider when you
remove it from the media press.
• When turning the main power switch off for moving
the machine or for solving the error or the like,
press the [END/POWER] key a long time on the
front of the machine, check the display is turned
off on the operation panel, and then turn the main
power switch off.
[END/POWER]
key
Main power
switch