MIMAKI TS55-1800 - Chapter 3 Setup (Continuing); Remote, Lighting, and Initialization Settings

Chapter 3 Setup
3-21
1
2
3
4
5
6
Automatic remote
When data is received in local mode, it automatically
switches to remote mode and starts printing.
1
Press
(MENU) (twice)
in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press
(>>)
.
3
Press to select "Auto Remote",
then press the key.
4
Press to select "ON/OFF", then
press the key.
• ON: When data is received in local mode, it
automatically shifts to REMOTE and starts
printing.
• OFF: Remote transfer by pressing
5
Press the key several times to
end the setting.
Lighting
The interior LED lighting in this machine is installed in two
places, the ceiling part and the maintenance space.
Lighting setting
1
Press
(MENU) (twice)
in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press
(>>)
.
3
Press to select "Illumination",
then press the key.
4
Press to select "Lighting Up
Type", then press the key.
5
Press to select setting value,
then press the key.
• Auto: Automatically turns on / off in conjunction
with print operation or maintenance work
(cover open etc.).
• Manual: Use this when you want to turn on / off
arbitrarily. If you chose manual, go to
step 6.
6
Press to select "Lighting Up
Extention" and press the key.
7
Press to select the set value and
press the key.
• Setting value: none / 0 to 10 min
8
Press to select "Start Up
Lighting" and press the key.
9
Press to select "ON / OFF", then
press the key.
• ON: When you want to light up when the
machine is activated
• OFF: When you do not want to light up when the
machine is running
10
Press the key several times to
end the setting.
Turning on lighting of interior lighting
1
Press key in local mode and press
(ADJUST).
• Adjustment menu is displayed.
2
Press , select "Toggle Internal
Lighting" and press key.
• Each time you press the key, the
interior lighting changes on and off.
Feeding before cut
When performing media cut ( P.2-13), the print result
can be cut at any place.
1
Press
(MENU) (twice)
in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press
(<<)
.
3
Press to select "Feeding before
cut", and press the key.
4
Press the key.
• The already configured settings are initialized.
5
Press the key several times to
end the setting.
Initializing the Settings
You can return the setting of "SETUP", "MAINTENANCE"
and "MACHINE SETUP" to the status before shipment.
1
Press
(MENU) (twice)
in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press
(<<)
.
3
Press to select "RESET", and
press the key.
• Turning off the automatic feed may cut off the
trailing edge of the printed result.