4-12
Chapter 4 Maintenance
15
When an "Operations complete" message
is displayed, open the front cover and
check the amount of cleaning solution in
the cap.
• If the cleaning solution is not full of cap, fill the cap
with the maintenance cleaning solution with a
dropper.
16
Close the front cover, and press the
key.
• After its initial operation, the machine returns to
the display in step 2.
Cleaning the Ink Head
and the Area Around It
Because the ink head employs a very precise
mechanism, due care needs to be taken when it is
cleaned.
Using a clean stick, etc., rub off gelatinous ink or dust that
may stick to the lower part of the slider and the area
around the ink head. In doing so, never rub the nozzles of
the head.
1
Press
(MENU)
in LOCAL.
2
Press to select
"MAINTENANCE", and press the
key.
• The MAINTENANCE menu is displayed.
3
Press to select "STATION
MAINT.", and press the key.
4
Press to select "CARRIAGE
OUT", and press the key.
• The carriage moves over the platen.
5
Press to select "Move to
Maintenance Space" and press the
key.
6
Open the maintenance cover.
Tools required for cleaning
• Cleaning Stick for Head Surrounding (PN:SPC-0527)
• Safety glasses • Gloves
• Be sure to wear the supplied safety glasses and
gloves when cleaning the area around the ink
head. Otherwise, you may get ink in your eyes.
• The ink contains organic solvents. If you get ink on
your skin or in your eyes, rinse thoroughly with a
lot of clean water.
To Next Page
Loading...
