MIMAKI TS55-1800 - Chapter 4 Maintenance (Continuing); Conditions Affecting Nozzle Recovery

4-15
1
2
2
4
5
6
Chapter 4 Maintenance
Check Conditions for Which Nozzle
Recovery Cannot be Performed
1
Press
(MENU)
in LOCAL.
2
Press to select
"MAINTENANCE", and press the
key.
• Maintenance menu will be displayed.
3
Press to select "NOZZLE
RECOVERY", and press the key.
4
Press to select "CHECK", and
press the key.
• Judgment Condition input screen will be
displayed.
5
Adapt each item of the judgment
conditions to your current state.
(1) Press [] [] to select the setting item, and
press the [ENTER] key.
(2) Press [] [] to select the setting value, and
press the [ENTER] key.
(3) Repeat steps (1) and (2) to set all of the
items.
6
Press the key.
• Begin to check if nozzle recovery at the set
printing conditions can be done.
• When the check is complete, the judgment result
is displayed on the screen.
7
Press several times to end
the setting.
Set Whether to Enable NOZZLE
RECOVERY During TEST PRINT
By setting the following to "ON" and registering the nozzle
numbers you want to recover using P.4-13 "Nozzle
Recovery Function", the Nozzle Recovery Function is
enabled when performing test printing ( P.2-10).
1
Press
(MENU)
in LOCAL.
2
Press to select
"MAINTENANCE", and press the
key.
• Maintenance menu will be displayed.
3
Press to select "NOZZLE
RECOVERY", and press the key.
4
Press to select "TEST PRINT",
and press the key.
5
Press to select ON/OFF, and
press the key.
6
Press several times to end
the setting.
Judgement Condition
Resolution
720 x 720
8 PASS
NORMAL
Scan Speed
>
MAPS 4
1
OVER PRINT
If nozzle recovery
possible
Judgement result
Judgement result
OK
HEAD1-A
1
HEAD1-B
0
HEAD1-C
0
HEAD1-D
2
NG
HEAD1-E
1
HEAD1-F
0
HEAD1-G
0
HEAD1-H
0
HEAD2-A
0
Judgement result
Judgement result
Judgement result
If nozzle recovery
is not possible
Head no. and
nozzle line
The number of
nozzles that cannot
be recovered.