4-21
1
2
2
4
5
6
Chapter 4 Maintenance
8
Attach the slider to the new media press.
• Hook the hole of the slider on the protrusion of the
media press.
9
Attach the media press.
10
Attach the media press stopper.
11
Close the maintenance cover.
12
Turn the main power switch ON.
(1) Set the main power switch located on the
side of this machine to the "I" side.
• When the power is turned on, the firmware
version is displayed and the initial operation
is executed.
(2) Press the [END / POWER] key to turn on the
power.
Replacing the Pinch roller
Replace the pinch roller (PN:SPA-0247) when it is worn or
dirty.
1
Turn OFF the power of the connected PC.
2
Turn the power off, by giving the
key a long press.
• The pinch roller is an optional item. You can buy
one through your local dealer or from our service
office.
• Since the parts are small, you need to take extra
care not to drop them into the gaps in the
machine.
• When turning the main power switch off for moving
the machine or for solving the error or the like,
press the [END/POWER] key a long time on the
front of the machine, check the display is turned
off on the operation panel, and then turn the main
power switch off.
Main power
switch
[END/POWER]
key
To Next Page
Loading...
