3-4
Chapter 3 Setup
Register the optimal print conditions
to match the use
In this machine, you will be able to register print
conditions, SETUP 1 to 4 individually to match the media
in advance.
For example, after print on different types of media, return
to the media always use. In such case you can set the
optimum printing conditions by simply selecting the
registered SETUP 1 to 4.
Register the print conditions to SETUP 1
to 4
1
Press
(MENU)
in LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• The item selected indicates ● and others show
○ .
• SETUP MENU will be displayed.
3
Press to select and set each item
in the setup menu list.
• Please see the reference page in the setup menu
list for detailed configuration procedure.
Reset the registered contents
Reset the contents registered to SETUP 1 to 4.
1
Press
(MENU)
in LOCAL.
2
Press to select SETUP 1 to 4 to
be reset and press the key.
• SETUP MENU will be displayed.
3
Press
(
<<).
4
Press to select "RESET
SETTING", and press the key.
• Confirmation screen of reset settings will be
displayed.
5
Press the key several times to
end the setting.
Setting of Media Correction
Correct the media feed amount to match the type of
media you are using.
If the correction value is not appropriate, stripes may
appear on the printed image, thus resulting in a poor
printing.
A pattern for media correction is printed and a media-
feeding rate is corrected.
1
Set a media. ( P.2-4)
2
Press
(MENU)
in LOCAL.
3
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
4
Press to select "FEED COMP",
and press the key.
5
Press the key twice to print a
correction pattern.
6
Check the correction pattern and enter a
correction value.
• A screen for entering the correction value will be
displayed.
• Enter a correction value in "+":
The boundary between the two bands is widened.
• Enter a correction value in "-":
The boundary between the two bands is
narrowed.
• When you change the correction value by "30", the
width of the boundary changes by about 0.1 mm.
7
Press the key.
• Print a correction pattern again and check it.
• When media correction is needed, perform the
operation in Step 7 to make correction.
8
Press the key several times to
end the setting.
• Print conditions that can be pre-registered with
the machine are the four types, "SETUP 1" to
"SETUP 4".
• On completion of [MEDIA COMP.] during use of a roll
media, the media returns to the printing origin. Then the
roll media in the rear of this machine will slacken.
Before printing, take up the slack in the roll media by
hand; a loose roll media can result in an inferior image
quality.
• When printing with a take-up device, set the media first
and then perform media correction.
• Two bands are printed in the correction pattern.
• Make adjustment so that an even color density is
obtained in the boundary between the two bands.
Second band
First band
Media advance direction
To Next Page
Loading...
