4-22
Chapter 4 Maintenance
3
Turn off main power switch.
• Tilt the main power switch on the side of the unit
to "" side.
4
Open the front cover.
5
Raise the clamp lever to keep the pinch
roller lifted.
6
Remove the O-ring retaining the pinch
roller.
7
Remove the pinch roller.
8
Insert a new pinch roller.
9
Insert the O-ring.
10
Close the front cover.
11
Turn the main power switch ON.
(1) Set the main power switch located on the
side of this machine to the "I" side.
• When the power is turned on, the firmware
version is displayed and the initial operation
is executed.
(2) Press the [END / POWER] key to turn on the
power.
Main power
switch
[END/POWER]
key
To Next Page
Loading...
