MIMAKI TS55-1800 - Chapter 2 Basic Operations; Chapter 2 Overview

This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow .......................................................2-2
Turning the Power ON/OFF ..........................2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-3
Setting a Media .............................................2-4
Adjusting the Head Height .......................... 2-4
Setting a roll media ..................................... 2-5
Take-up device ............................................ 2-8
Changing the printing origin ........................ 2-9
Preparing for the Heaters ..............................2-9
Changing the Temperature Settings for the
Heaters ........................................................2-9
Test Printing ................................................2-10
Test Printing .............................................. 2-10
Head Cleaning ............................................2-11
About head cleaning ..................................2-11
Perform head cleaning depending on the test
printing result .............................................2-11
Setting of Media Correction .........................2-12
Setting of Media Correction .......................2-12
If the Positions of Dots Shift... .....................2-12
Printing Data ...............................................2-13
Starting a Printing Operation .....................2-13
Stopping a Printing Operation ....................2-13
Deleting Received Data (Data Clear) ........2-13
Cutting a media ..........................................2-13
Chapter 2
Basic Operations