MIMAKI TS55-1800 - Chapter 3 Setup; Chapter 3 Overview

This chapter
describes the various setting of this machine.
About SETUP MENU ....................................3-2
SETUP MENU table.................................... 3-3
Register the optimal print conditions to match
the use ........................................................ 3-4
Setting of Media Correction......................... 3-4
If the Positions of Dots Shift... ..................... 3-5
Setting the HEATER ................................... 3-6
Setting of Logical Seek ............................... 3-6
Setting of Overprint ..................................... 3-6
Setting of Drying Time................................. 3-7
Setting of Left and Right Margins................ 3-7
Setting of Vacuum Fan................................ 3-7
Setting of Feed Speed ................................ 3-8
Setting Auto Cleaning ................................. 3-8
Setting External heater................................ 3-9
Setting of MAPS4........................................ 3-9
Pass density correct.................................. 3-10
Setting Pre-feed ........................................ 3-10
Change of setting type name .................... 3-10
About MACHINE SETUP MENU ................3-11
MACHINE SETUP MENU table ................ 3-12
Setting a AUTO Power-off......................... 3-14
Setting Take-up unit .................................. 3-14
Setting Top Blower.................................... 3-14
Setting the Display of Media Residual ...... 3-14
Setting the Media Detection ...................... 3-15
Setting a LANGUAGE................................ 3-15
Setting a Time............................................ 3-15
Setting Unit (Temperature/ Length) ........... 3-16
Setting a KEY BUZZER............................. 3-16
Setting the VIEW FEED............................. 3-16
Setting the space between prints............... 3-16
Setting the SPACE FEED MODE.............. 3-16
Set the network.......................................... 3-17
Setting event mail function......................... 3-17
Automatic remote....................................... 3-21
Lighting ...................................................... 3-21
Feeding before cut..................................... 3-21
Initializing the Settings............................... 3-21
About NOZZLE CHECK MENU ..................3-23
INFORMATION MENU table ..................... 3-23
Printing Check Flow................................... 3-24
Printing Operations at "Nozzle Missing"
Judgment and Error Occurrence ............... 3-24
Setting the Printing Check ......................... 3-25
Setting the NOZZLE RECOVERY ............. 3-25
Setting the Judgment Condition................. 3-25
About INFORMATION MENU .....................3-26
INFORMATION MENU table ..................... 3-26
Displaying the Information ......................... 3-27
Display maintenance status
(local guidance) ......................................... 3-27
Chapter 3
Setup