MIMAKI TS55-1800 - Chapter 4 Maintenance; Chapter 4 Overview

This chapter
describes the items required to use this machine more comfortably, which are the
methods for the daily care, the maintenance of the ink cartridges etc.
Maintenance .................................................4-2
Precautions for Maintenance ...................... 4-2
About Cleaning Solution.............................. 4-2
Cleaning the Exterior Surfaces ................... 4-2
Cleaning the Platen ..................................... 4-2
Cleaning the Media Sensor ......................... 4-3
Cleaning the Media Press ........................... 4-3
Maintenance of Ink Pack ............................. 4-3
About MAINTENANCE MENU ......................4-4
MAINTENANCE MENUs table .................... 4-5
Maintaining the Capping Station ...................4-6
Cleaning the Wiper ...................................... 4-6
Cleaning the Cap ........................................ 4-7
Cleaning the Cap Absorber ......................... 4-7
Nozzle cleaning ........................................... 4-8
Cleaning the Ink Discharge Passage .......... 4-9
When the Machine Is Not Used for a Long
Time .......................................................... 4-10
Cleaning the Ink Head and the Area
Around It .....................................................4-12
Nozzle Recovery Function .......................... 4-13
Reset the Set Value .................................. 4-14
Check Conditions for Which Nozzle Recovery
Cannot be Performed ................................ 4-15
Set Whether to Enable NOZZLE RECOVERY
During TEST PRINT ..................................4-15
Auto Maintenance Function ........................4-16
Setting the Refreshing Intervals .................4-16
Setting the Cleaning Intervals and Type ....4-16
Replacing Consumables .............................4-17
Replacing the Wiper ..................................4-17
Replacing the Wiper Cleaner .....................4-17
Replacing the Cap .....................................4-18
Replacing the Cap Absorber ......................4-19
Replacing the Media Press ........................4-20
Replacing the Pinch roller ..........................4-21
Replacing the Carriage filter ......................4-23
Male Connector Absorbent for MBIS .........4-24
Replacing the Blow down fan filter .............4-24
Replacing the Cutter Blade ........................4-25
Waste ink tank management .......................4-26
Correction of waste ink amount .................4-26
Change of tank capacity ............................4-26
If a Waste Ink Tank Confirmation Message
Appears .....................................................4-26
Replace the waste ink tank with another ...4-26
Chapter 4
Maintenance